DVR-IP4CF
11
7. OPERATING PROCEDURE
7.1 Power On
When powered on, the DVR will auto-detect its peripherals (self-testing, warm-up,
auto detects the hard disk and starts CF-card testing, and etc.)
The system will detect the video input and judge whether the video system is
NTSC or PAL. When video input is unable to be detected (VIDEO LOSS), the
system will send out an alarm, press any button to stop the alarm (it will not affect
the actual recording). Always connect cameras to the DVR before powering up to
properly detect the cameras.
7.2 Monitoring Mode
This mode is the default for our system after power on. Under this mode, system
supports live view for monitoring. Press
《
REC
》
button, the system enters the record
mode, press
《
PLAY
》
button to start playback, press
《
MENU
》
button to enter the menu
setup display. During record or playback, press
《
STOP
》
button to stop the current
activity and returns to monitoring mode. Under the main menu, press
《
MENU
》
to
return to monitoring mode.
During playback, press
《
STOP
》
button to return to monitoring mode. Press FF
to change the speed (FF1, FF2 or FF3), or press
《
REW
》
button to start reverse
playback.
~
To reset the DVR to factory defaults (under quad or single display), press
《
PAUSE
》
button 5 times, the message
《
ALL SETTING DATA IS INITIALIZED.
》
will be displayed by flashing 3 times, and after reset the password will be set as
default value (111111).
~
When the reset procedure has been completed, the message
“
DVR RESET
COMPLETED. TURN THE DVR ON & OFF
＂
will be displayed, then please
restart the DVR.
Summary of Contents for DVR-IP4CF
Page 43: ...DVR IP4CF 42 Start up ActiveX Control...
Page 60: ...DVR IP4CF 59 Figure 2 Figure 3...
Page 61: ...DVR IP4CF 60 Figure 4 Figure 5...
Page 65: ...DVR IP4CF 64 MEMO...
