7
Dome Camera Control
Dome Camera Connection & Settings:
•
See section Pin Definition of Alarm I/O & RS-485, and Audio In for RS-485 port pin definition.
•
Connect the R+, R- terminals on the dome camera to the D+, D- terminals on the RS-485 port
by RS-485 cable respectively.
•
To set up dome camera’s protocol and ID, press
MENU
to access the OSD main menu or
change the protocol and ID by using SpecoRemote, and select <
Camera Setup
>. The available
protocols include <
Speco
>, <
DSCP
>, <
AD422
>, <
Pelco D
>, <
Pelco P
>, <
Fastrax 2
>, <
JVC
>,
<
Panasonic_C
>, and <
Panasonic_N
>. The default is <
None
>. Note that ID number must
match the ID address defined by the dome camera.
•
To configure the RS-485 parameters, select <
System Setup
> from OSD main menu or through
SpecoRemote, and then select <
RS485 Setup
>. The default RS-485 settings are 9600 Baud, 8
Data Bits, 1 Stop Bit and No Parity.
