12
5.2. SHIFTING - MECHANICAL SYSTEM
FIG. 2:
Route the derailleur housings.
•
Run the rear derailleur housing in through the rear dropout ICR port, over the bottom bracket shell,
up the down tube and out the upper head tube hole.
•
Run the front derailleur housing in through the bottom bracket ICR port, up the down tube and out
the upper head tube hole.
When running a 2x chainring setup, we recommend using a front derailleur
that requires full length housing all the way to the derailleur.
•
DERAILLEURS WITH EXPOSED HOUSING UP TO THE DERAILLEUR CABLE STOP (fig.
2a):
Place the grommet (S169900008) over the shift housing and into the frame’s ICR port.
•
DERAILLEURS WITH EXPOSED CABLE FROM THE FRAME TO THE PINCH BOLT (Fig. 2b):
Place the housing stop (S206500007) into the front derailleur ICR port behind and above the bottom
bracket shell. Rotate the grommet to ensure it is fully seated as deep as possible into the frame.
•
Install Churros (foam sleeve) over the shift housings, then run the Churros into the down tube. The
Churros must start 20mm below the head tube/down tube kink and the rear shift housing must end
40mm behind the bottom bracket shell.
5.3. BRAKES
The following steps explain routing the housings through the frame and fork.
For additional information about the positions of the housings as they exit the
head tube, refer to page 15, as well as the inset illustrations in Fig. 1&2.
FIG. 1 or 2:
Route the rear brake housing.
•
Run the rear brake housing in through the chainstay ICR port, over the bottom bracket shell, up the
down tube and out the upper head tube hole.
•
Install a Churro over the rear brake housing. The Churro must start 20mm below the head tube/
down tube kink and end 40mm behind the bottom bracket shell.
•
Install a grommet over the brake housing and into the chainstay ICR port.
•
Install the caliper on the chainstay. Torque the caliper bolts according to the brake manufacturer’s
instructions.
FIG. 1-3:
Route the front brake housing.
•
Run the front brake housing in through the lower ICR port in the fork and guide it up in the fork leg
until it exits at the housing port in the front of the steerer tube. Use a pick to help guide the housing
out through the port.
•
Install the caliper on the fork leg. Torque the caliper bolts according to the brake manufacturer’s
instructions.
3
TAPE
HOUSING EXIT PORT
GROMMET
•
Fig. 3:
Once the brake is mounted to the fork, secure the brake housing to the steerer tube with a
section of strong adhesive tape. A variety of tape types can be used.
•
Install the housing grommet into the ICR port on the fork leg.
Summary of Contents for TARMAC SL7
Page 1: ...USER MANUAL...
Page 2: ......
Page 9: ...6 A B M C D P E F G H I J K L N O...
Page 31: ......
