Fig.1f
Fig.1g
Fig.2a
2. HARNESS ADJUSTING
With
•
the user sat in the wheelchair, pull the Chest Straps so that there is only 75mm
(3”) of webbing through the buckle to the ‘D’ ring (Fig.2a).
Take
•
up the slack webbing by pulling it through the two Bar Slides, making sure the
bar slides are evenly spaced, roughly in the middle of the wheelchair back. Thread
the second Chest Strap fully through the second Bar Slide (Fig.2b) to lock off the two
Chest Straps.
Cut
•
off any excess webbing and seal cut end with match/lighter.
Fig.2b
1. WEBBING GUIDE & HARNESS FITTING (Cont.)
Thread
•
the second Chest Strap through one side of the second Bar Slide
(Fig.1f).
With
•
the user in place, position the Chest Pad just below the chest and clip to the
Chest Straps (Fig.1g).
