18
2.3. ARMREST OPERATION (if fitted)
Make
•
sure that both brakes (refer to page 3 for
brake type) are applied to the rear wheels (Fig.2.3a).
Locate
•
the armrest stem in the mounting socket
(Fig.2.3b), set the armrest at the required height
and tighten the knob (Fig.2.3c). Please note: the
armrests can be fitted and used in the forward or
reverse position.
Slide
•
the locking collar down on to the socket
(Fig.2.3d) and tighten the grub screw (this allows the
height to be retained when replacing armrest after
removal).
Armrests
•
can be moved in-board or out-board by releasing the screw & lock nut on the
upper frame and sliding in or out to the required position, re-tighten screw & lock nut
when finished (Fig.2.3e).
To
•
remove armrests for transport, etc, release the knob on the socket and lift out. If at
any time you require the height to be altered you must release the grub screw on the
locking collar.
DO NOT
•
at any time lift the wheelbase via the armrests as this can result in
damage or injury.
Fig.2.3b
Fig.2.3c
Fig.2.3d
Fig.2.3e
Fig.2.3a
