18
Customer Helpline
0151 649 1500
It essential for the smooth operation of the chainsaw to use the correct type of fuel and oil.
The chainsaw utilises a 2-stroke engine which runs on a mixture of regular unleaded fuel and
2-cycle engine oil mixed at a ratio of 40:1.
The chainsaw will operate with any brand or grade of regular unleaded fuel which is designed for
automotive use.
3a. Filling the Mixing Container with Fuel and Oil
WARNING!
Before attempting to mix fuel and oil, always ensure all sources of ignition are removed
i.e. naked flames.
WARNING!
The chainsaw should
NOT
be used with petrol only. This will cause permanent damage
to the engine and will void your warranty.
CAUTION!
Only use premium grade oil for 2-cycle air cooled engines designed to be mixed to a ratio
of 40:1. Under no circumstances should oils designed for 100:1 mixes be used. Failure to observe this
caution may prevent the engine from being suitable lubricated.
CAUTION!
Using 2-cycle oils designed for mixing ratio other than 40:1 will void your warranty.
CAUTION!
Do not use a fuel/oil mixture which has been stored for more than 90 days.
NOTE!
It is recommended that a full container of fuel and oil is mixed every time to ensure the correct
mixing ratio is achieved.
Fill the supplied mixing container
with approximately 500 ml of regular unleaded fuel. This level
is indicated on the side of the container.
Add 2-cycle oil to the mixing container
to fill up to the 40:1 oil indication
. This requires 12.5 ml
of oil.
3b. Mixing Fuel and Oil
Ensuring the top of the mixing container
is fitted and fully tightened, shake vigorously for
30 seconds.
Step 3 - Fuel and Lubrication (continued)
Preparing to Operate the Chainsaw
