12
).34!,,!4)/.#/.3)$%2!4)/.3
DO:
s0LACETHEAMPLIFIERWITHTHEFEETRESTINGONASOLIDFLAT
level surface.
s0LACETHEAMPLIFIERINAWELLVENTEDAREATOPROVIDE
proper cooling. In areas that lack proper ventilation, such
as tight cabinets or racks, it may be necessary to install
small fans to create air movement.
DON’T:
s$ONTBLOCKTHEVENTILATIONHOLESONTHETOPORBOTTOM
of the amplifier. Never place it on carpeting or similar
material.
s$ONTPLACETHEAMPLIFIERINANYOTHERPOSITIONOTHERTHAN
horizontal with the feet down. Never place on its side or
resting on the back where the terminals are located.
s$ONTPLACETHEAMPLIFIERNEARHEATSOURCESORINANAREA
that it would be exposed to moisture.
YOU SHOULD KNOW
s4HEPOWERSUPPLYISVERYLARGEANDTHEREFOREMAYCAUSE
a hum to be heard in some components if they are
placed very close to the amplifier.
CAUTION: All connections and switching must be done with
the amplifier’s master power switch positioned to “off”.
3ELECTTHE0OWER-ODE3ELECTION
Refer to the Power Mode Selection area under system design
and operations considerations to determine which setting
to use to turn the amplifier on. Once you have determined
which mode you will be using set the switches as outlined in
the following chart:
).34!,,!4)/.
3WITCH3ETTINGS
!CTIVE,IGHT
3ELECTION
-ODE
Constant
Power button will light
up when the amplifier
is “On/Active” and will
go off when it is “off”.
Power Mode Selection
= Set to “Constant”.
Master Power Button
= Depress to “In”
position to turn
amplifier “On”, out
position is “Off”.
Trigger
Power button will
light up only when
the amplifier receives
an audio signal to the
main inputs indicating
the amplifier is “ON”/
active. Will turn off
three minutes after the
signal has stopped.
Power Mode Selection
= Set to “Trigger”.
Master Power Button
= Leave in the “On”
position (Button
Depressed).
Audio Sense
Power button will
light up only when
the amplifier receives a
voltage indicating the
amplifier is “On/Active”.
Will turn off once the
voltage has stopped.
Power Mode Selection
= Set to “Audio
Sense”.
Master Power Button
= Leave in the “On”
position (Button
Depressed).
