Nortek Security & Control LLC
7
9. USB Connector.
The USB connector is used to power the optional
subwoofer wireless receiver .
Do not plug in other USB devices into
this port, as it may damage the subwoofer or the device.
Refer to the
wireless receiver installation instructions for more details .
10. Mounting Standoffs.
The mounting standoffs are used to mount the
optional subwoofer wireless receiver . Refer to the wireless receiver
installation instructions for more details .
11. IEC Power Connector.
The subwoofer comes with a detachable line cord
that attaches here . Make sure it is firmly pushed into place . Connect the
other end to a properly configured AC outlet designed for the type of plug
with the correct voltage for your model .
12. AC Line Fuse.
The subwoofer is supplied with a conservative slow-blow
type fuse to protect the electronics . If this fuse fails, replace it with the
exact same type and current rating for your local AC voltage . This rating
is marked on the control panel near the fuse holder .
NOTE:
Always unplug the power cord from your AC outlet before
removing the fuse . To replace or inspect the fuse, use a small
flathead screwdriver to gently pry out the fuse carrier and fuse .
s
ubwoofer
p
laCemenT
Subwoofer placement can greatly influence its performance . All rooms are
different, but the loudest output will likely occur if the subwoofer is placed
in a corner of the room on the same wall as the front channel speakers . You
may need to experiment with more than one location, always testing the
sound from the primary listening position until you find the right balance and
consistency in the bass performance .
