Page 2
Eazy6 Owner’s Manual
BassX-8/10/12 Owner’s Manual
Page 3
INTRODUCTION
The BassX-8, BassX-10 and BassX-12 provide accurate bass to any audio system, and are designed to work in conjunction with your other
audio components. They can be connected to any surround sound receiver that has a subwoofer output; any receiver that has a built-in
preamplifier; or any receiver that has speaker level outputs. The pass-through feature of the BassX-8, BassX-10 and BassX-12 allows the left and
right line level input signals to be fed out of the unit to other amplifiers or system components.
PLACEMENT
For optimal performance, the BassX-8, BassX-10 or BassX-12 should be placed in a corner along the same wall as the front speakers. The unit
is shielded, so it is safe to place near video devices. When choosing a place for the BassX-8, BassX-10 or BassX-12, please keep the following
in mind:
DO
• Place the BassX-8, BassX-10 or BassX-12 with its feet resting on a solid flat level surface.
• Place the BassX-8, BassX-10 or BassX-12 in a well-vented area to provide proper cooling. In areas that lack proper ventilation, such as
tight cabinets or racks, it may be necessary to install small fans to create air movement.
DON’T
• Obstruct the driver or ports of the BassX-8, BassX-10 or BassX-12 as that will hinder performance.
• Place the BassX-8, BassX-10 or BassX-12 in any position other than horizontal with the feet down. Never place on its side or resting
on the back where the terminals are located.
• Place the BassX-8, BassX-10 or BassX-12 near heat sources, or in an area that it would be exposed to moisture.
INSTALLATION
Connecting the Line Level Audio Inputs
(See Diagram 1)
If your surround sound receiver or amplifier has only one subwoofer output, simply plug it into the
Left Line Level Input.
(See Diagram
2)
If your receiver or amplifier has a built-in preamplifier, the left and right pre-outputs can be con-
nected to these line level inputs.
(See Diagram 3)
CAUTION:
Only make connections when the BassX-8, BassX-10 or BassX-12
is turned off.
Connecting the Line Level Audio Outputs
(See Diagram 1)
Sources connected to the left and right line level inputs can be forwarded to other components or
amplifiers by connecting to the corresponding output sections to the left of each input section. If
your receiver or amplifier has a built-in preamplifier, the left and right pre-inputs can be connected
to these line level outputs.
(See Diagram 3)
Use the Frequency Knob on the BassX-8, BassX-10 or
BassX-12 to adjust the high pass crossover.
CAUTION:
Only make connections when the BassX-8,
BassX-10 or BassX-12
is turned off.
DIAGRAM 1:
Line Level Input/Output
