INTRODUCTION
Congratulations on your purchase of the Bass Power amplifier! The Bass Power amp will provide the excellent performance
and reliability that SpeakerCraft products have been recognized for. To receive the best performance from your Bass Power
amp, please carefully read the instructions in this manual. For technical inquires, please call 1-800-448-0976 or e-mail us at
[email protected].
2
PLACEMENT
DO:
• Place the amplifier with the feet resting on a solid flat level surface.
• Place the amplifier in a well-vented area to provide proper cooling. In areas that lack proper ventilation, such as tight
cabinets or racks, it may be necessary to install small fans to create air movement.
DON’T:
• Don’t block the ventilation holes on the top or bottom of the amplifier. Never place it on carpeting or similar material.
• Don’t place the amplifier in any other position other than horizontal with the feet down. Never place on its side or
resting on the back where the terminals are located.
• Don’t place the amplifier near heat sources, or in an area that it would be exposed to moisture or excessive humidity.
YOU SHOULD KNOW
• The power supply may cause a hum to be heard in some components if they are placed very close to the amplifier.
INSTALLATION
Please use Diagram 1 to familiarize yourself with the rear panel of the Bass Power amplifier.
IEC Power
Connector
Line Inputs
Volume Limit
Control
Fuse
Low Pass
Crossover
Control
Serial Number
Speaker Input Terminals
Speaker Output Terminals
LFE Input
Line
Outputs
Bass
Boost
Control
Phase Switch
Subwoofer
Output Terminals
Power Switch
DIAGRAM 1
Bass Power Rear Panel
PRINTING INSTRUCTIONS: Bass Power MANUAL - INK: BLACK (1 over 1) - MATERIAL: 80lb Gloss - SIZE: 8.500” x 11.000”
