SPEAKER INSTALLATION
The unique integral four foot mounting system incorporated into each speaker allows for quick installation following these easy
steps:
1.
If the grille is on the speaker, remove it. It may be necessary to push one or two of the mounting screws and its attached
foot towards the baffle and against the inside surface of the grille to force the grille out of its retaining groove.
2.
Attach the speaker cable (observing the proper polarity with your amplifier: + to + and – to –). Make sure the left channel
of the amplifier is connected to the left speaker, and the right channel is connected to the right speaker.
3.
Make sure the mounting feet are turned inward to clear the opening, and insert the speaker into the ceiling. Position the
speaker into the hole.
Note:
The flange of the speaker is designed to flex and conform to any small imperfections in the
ceiling surface. Tighten the 4 screws on the front of the baffle only enough to make the flange become snug against the
ceiling. As you tighten the screws, the feet will automatically flip into an outward position
(See Figure 3)
clamping the
drywall between the feet and the flange.
CAUTION:
Over tightening may warp the baffle, crack the ceiling, cause the
flange to distort, and make the grille difficult to install.
Figure 3
3
SIDE VIEW OF CEILING
First Cut
Second Cut
Figure 2
PRINTING INSTRUCTIONS: AIM WIDE MANUAL - INK: BLACK (1 over 1) MATERIAL: 80lb Gloss - SIZE: 11" x 17" folded to 8.5” x 11”