www.spatz-tech.de
4.1.2 Menu structure and submenus
The unit has 3 main submenus that are controlling EDID, System settings and device settings. You may
reach them using the RIGHT arrow button. Use UP and DOWN button to cycle through the settings.
Use the right button to initiate the blinking cursor, then use UP and DOWN button to change the setting.
4.1.3 DEVICE GROUP
LED Brightness
0-10
LCD Backlight
0-10
LCD Contrast
0-10
Int. IR Remote
on/off
Deactivates/Activates the front IR receiver
Int. IR Indication
on/off
If active POWER LED will blink while receiveing IR commands
4.1.4 SYSTEM GROUP
Sys Temperature
Display will show internal temperature in degrees centigrade
Reset to Default
go to 4.3
Remote Control
The MATRIX-X1616 has 3 options for remote control
R
= RS-232
E
= Ethernet using GUI
T
= Telnet (RS-232 commands via Ethernet)
You can see the current remote setting in the upper right corner of the main display that can be reached
using the LEFT button !
4.1.5 EDID MANAG. GROUP
The most powerful tool of our MATRIX-X1616 is the EDID management and our unique SingleEDID
technology. Opposite to extenders that should be EDID transparent and forward the display EDID to the
source a matrix requires the exact opposite. Since a matrix can have a variety of different displays
connected to the outputs and it is most likely that one input is connected to all available outputs there is no
choice but controlling the EDID for the sources. We have several options how to control the EDID.
They are explained in the following paragraphs.
Once you have reached the EDID MANAG. GROUP following settings are available:
EDID Control
Common/Individual
This setting determins if EDID information is programmed for each input individually
(Individual)
or all inputs have the same EDID programming
(Common).
Typically
you would work in the COMMON setting (Default) and after selecting or programming
the SingleEDID the unit would copy the setting to all other inputs. Individual EDID
programming could be necessary if you have special requirements or work in a
multiroom setup.
Input Select
If you have chosen INDIVIDUAL EDID programming you can now select the Input
you want to change. After having selected the input you can choose between the
following EDID options.
Do not forget to STORE !!!
EDID Mode
Learned /SingleEDID/Default EDID/3D 8CH Audio/3D 2CH Audio
use right arrow button to change, up/down button to cycle through the options
DEFAULT
EDID Information is (1280x720p/60Hz), this is an EDID that is compatible with most
displays on the market
3D All Audio
Both of these contain a 3D EDID as required by BluRay Players to activate the 3D
3D 2CH Audio
output. One is set for 2 CH PCM audio the other for 8 Channel PCM.
