GB
8
2.6 INSTALLATION / ASSEMBLY
The architecture SL must be aligned horizontally
and protected against tilting. Take the safety dis-
tances into account (see 2.7). Rear ventilations
must not be closed. Place the burner with safety
container and cover plate in the holders in the
holders in the furniture.
The architecture SL may only be set up on floors with sufficient load-bearing
capacity. If the load-bearing capacity is not sufficient, suitable measures
(e.g,. plate for load distribution) must be taken to remedy this.
The concrete base is solid and weighs > 40kg. At least 2 people are
required in order to set and move the concrete base. Take care to prevent
the edges and corners of the base from either being damaged or causing
damage when moving it.
Slight imperfections and unevenness in the concrete surface and chipped
edges are typical of this material and are not a reason for complaint!
2.6.1 POSITIONING OF THE BURNER
The burner should be placed in the furniture by two people.
Proceed as follows:
1. After unpacking the architecture SL, position the concrete base where
you wish to set it up whilst observing points 2.5, 2.6 and 2.7.
2. Firstly place the burner in the holder (Fig. 3a).
3. Then insert the four glass holders. (Fig. 3b).
4. Finally insert the glass (Fig. 3c).
Fig. 3a
Fig. 3b
Fig. 3d
Fig. 3c
Burner
Holder
Concrete furniture
