Page 7
The green-colored rigid ear (or lug), extending from the adapter must be connected to a permanent
ground such as a properly grounded outlet box.
Don’t assume that all three-hole outlets are properly installed.
Check the outlet and
also the adapter, if used, with an outlet testing device which quickly indicates if a ground is
connected. Correct a faulty test indication before proceeding. The use of a Ground Fault Interrupter
is the safest means to check for proper grounding.
B.
EXTENSION CORDS —
Plug the power cord attached to the SparVision 200 directly into an inspected outlet. If an extension
cord must be used, it must be of an approved three-wire type in good condition, equipped with a
three-prong plug. Never cut off the grounding prong for use in a two hole outlet receptacle. By
doing so you have cut off your protection from shock.
C.
OUTDOOR EXTENSION CORDS —
When Spartan Tool equipment is used outdoors, use an extension cord intended for use outdoors
and so marked.
D.
AVOID ELECTRICAL CORD ABUSE —
Never move or lift Spartan Tool equipment by the cord. Do not yank cord at one end to disconnect
it from the receptacle. Keep cord away from heat, oil and sharp edges to avoid damage. Always
replace or repair damaged cords.
E.
ALWAYS WEAR RUBBER BOOTS IN WET AREAS FOR ADDED PROTECTION
WARNING:
SPARTAN TOOL PRODUCTS ARE NEVER TO BE OPERATED IN AN EXPLOSIVE
ENVIRONMENT.
CAUTION #2
Avoid eye or skin contact with acids or caustic substances while inspecting drains/sewers.
A.
Always wear safety goggles when inspecting drain/sewers to avoid injury to eyes.
Safety Instructions (cont.)
Safety Instructions (cont.)
Safety Instructions (cont.)
Safety Instructions (cont.)
Safety Instructions (cont.)
