Spartan Equipment 75594, Operator And Parts Manual

Page: 14 / 45

4.
INSTALLATION
FIXED SKID HOE HYDRAULICS
If installing a fixed skid hoe onto your unit, finish the installation by connecting the couplers
on the bucket hoses to the auxiliary hydraulic couplers on your prime mover. Start the engine and
slowly cycle the cylinder several times to purge system of air and check for proper hydraulic
connection, hose routing and hose length. Check for any hydraulic leaks and correct if necessary.
SWING SKID HOE HYDRAULICS
If installing a swing skid hoe onto your unit, there are three different hydraulic kit op-
tions.
DUAL AUXILIARY HYDRAULIC KIT
If using the dual auxiliary hydraulic kit connect the couplers coming from the bucket cyl-
inder and the swing cylinder to the auxiliary hydraulic couplers on your prime mover. Route the
hoses in such a fashion as to prevent chafing and pinching. Start the engine and slowly cycle the
cylinders several times to purge system of air and check for proper hydraulic connection, hose
routing and hose length. Check for any hydraulic leaks and correct if necessary.
2-SPOOL VALVE HYDRAULIC KIT
If using the 2-spool valve kit, mount the valve to the power unit in such a fashion that the
control handles are easily accessible for operation of the attachment. Apply the operation decal
next to the valve, making sure you do not cover up any existing safety decals.
To Apply Decal: Clean area of application with nonflammable solvent, then wash the same
area with soap and water. Allow the surface to fully dry. Remove the backing from the decal,
exposing the adhesive surface. Apply the decal and smooth out any bubbles.
Connect the quick couplers to the auxiliary hydraulic couplers on your unit. Route the
hoses in such a fashion as to prevent chafing and pinching. Start the engine and slowly cycle
the cylinders several times to purge system of air and check for proper hydraulic connection,
hose routing and hose length. Check for any hydraulic leaks and correct if necessary. Verify that
the cylinders function according to the operational decal. (If cylinders do not function according
to the decal, check for correct hose installation at the valve.)
FIGURE #1
PLACE DECAL
CLOSE TO VALVE
MOUNT VALVE CLOSE
TO OPERATOR
HANDLES NOT SHOWN
OPERATION DECAL
SWING BUCKET
CONTROL CONTROL
LEFT DIG
RIGHT
DUMP
10346 8-18-05
12 75594