5
EN
Original instructions
ing power tools. Such preventive safety
measures reduce the risk of starting the
power tool accidentally.
d)
Store idle power tools out of the reach
of children and do not allow persons
unfamiliar with the power tool or these
instructions to operate the power tool.
Power tools are dangerous in the hands of
untrained users.
e)
Maintain power tools. Check for mis
-
alignment or binding of moving parts,
breakage of parts and any other condi
-
tion that may affect the power tool’s op
-
eration. If damaged, have the power tool
repaired before use.
Many accidents are
caused by poorly maintained power tools.
f)
Keep cutting tools sharp and clean.
Properly maintained cutting tools with
sharp cutting edges are less likely to bind
and are easier to control.
g)
Use the power tool, accessories and
tool bits etc. in accordance with these
instructions, taking into account the
working conditions and the work to be
performed.
Use of the power tool for op-
erations different from those intended could
result in a hazardous situation.
5) Service
a)
Have your power tool serviced by a
qualified repair person using only iden
-
tical replacement parts.
This will ensure
that the safety of the power tool is main-
tained.
IV - Additional safety
rules for sabre
saws
WARNING:
Before connecting a tool
to a power source ensure that the voltage
supply is the same as that specified on the
nameplate of the tool.
▪ A power source with a voltage greater than
that specified for the tool can result in serious
injury to the user, as well as damage to the
tool.
▪ If in doubt, do not plug in the tool.
▪ Using a power source with a voltage less than
the nameplate rating is harmful to the motor.
Wear ear protectors with sabre saws.
Exposure to noise can cause hearing loss.
During operation provide eye protec-
tion to prevent eyes from exposure to fly
-
ing particles.
Wear goggles.
Take protective measures against inha
-
lation of dust. Some materials can contain
toxic ingredients. Wear a dust mask and
work with dust/chip extraction when connect
-
able.
Wear safety gloves.
▪
Hold power tool by insulated gripping sur
-
faces only, when performing an operation
where the cutting accessory may contact
hidden wiring or its own cord. Cutting ac-
cessory contacting a “live” wire may make ex-
posed metal parts of the power tool “live” and
could give the operator an electric shock.
WARNING:
Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance.
▪ The outer metal parts and the blade may get
hot after continuous operation. Do not touch
the blade or the work piece immediately after
operation - they may be extremely hot and
you may get serious burns.
▪ Keep your hands away from rotating parts.
▪ Use clamps or a vice to secure your work
whenever possible.
▪ Always switch the machine off and wait until
the blade has come to a complete stop before
placing the machine down.
▪ Do not overload the machine: operate with
moderate pressure. Overloading occurs when
you apply excessive pressure, resulting in
decrease of motor speed, which may cause
inefficient operation and possible fault of the
motor.
▪ Rags, cloths, cord, string and the like should
never be left around the work area.
▪ Before using the tool on an actual work piece,
switch on and let it run for a while. Operate
the tool at least 200 mm away from your face
and body.
▪ Always be sure you have a firm footing. Be
sure no one is below when using the tool in
high locations.
▪ Hold the power tool firmly.
▪ The tool must be used only for its prescribed
Та
ше
в
-
Га
лв
ин
г
ОО
Д
www.tashev-galving.com
