9
Original instructions
EN
CLEANING
For safe operation always keep the machine
and its ventilation slots clean.
Regularly check to see if any dust or foreign
matter has entered the ventilation slots and the
grills around the switches. Use a soft brush and/
or air jet to remove any accumulated dust. Wear
safety glasses to protect your eyes whilst clean-
ing.
Exterior plastic parts may be cleaned with a
damp cloth and mild detergent if necessary.
WARNING:
Never use alcohol, petrol
or other cleaning agent. Never use caustic
agents to clean plastic parts.
WARNING:
Water must never come
into contact with the tool.
IMPORTANT!
To assure product safety and re-
liability, repairs, maintenance and adjustment
(including brush inspection and replacement)
should be performed by certified service centres
or other qualified service organisations, always
using genuine replacement parts.
PREVENTIVE MAITENANCE
This power tool shall be submitted periodically
to SPARKY authorised service centre for pre-
ventive maintenance. Preventive checks will
boost the life of your power tool.
first check
- After approximately 70 h opera
-
tion.
The functioning of the machine shall be evalu-
ated and if necessary the machine shall be
checked.
Second check
- After approximately 140 h op-
eration or upon the event of brushes wearing
out.
The machine shall be cleaned thoroughly and
checked. Ascertained or potential faults shall be
eliminated (brushes and O-ring sealings shall be
replaced).
Third check
- After approximately 250 h opera
-
tion or upon the event of brushes wearing out.
The machine shall be cleaned thoroughly and
checked. Ascertained or potential faults shall be
eliminated (brushes and O-ring sealings shall be
replaced).
fourth check
- After approximately 350 h oper-
ation or upon the event of brushes wearing out.
The machine shall be cleaned thoroughly and
checked. Ascertained or potential faults shall be
eliminated (brushes and O-ring sealing shall be
replaced).
BUILT-IN DUST PROTECTION
The protective ring 2 preserves the tool socket
from dirt during operation. While inserting the
tool, take care that you do not damage the pro-
tective ring.
WARNING:
Replace a damaged pro-
tective ring immediately!
To replace the protective ring 2, pull back the
locking sleeve 3. Grasp the protective ring and
pull it strongly slantwise forward. Place a new
protective ring onto the spindle and press it
hard.
Summary of Contents for BP 330E
Page 2: ...B 2 3 4b 4a 7 6 8 10 1 5 9 А 8 2 3 4 5 1 9 10 6 7 ...
Page 110: ......
