All the [GPIO] Pins
Remember our "All the Pins!" nickname? Well, we meant it. On the MicroMod ATP, not only have we broken out all
the major pins with female headers, we've added a secondary rail of plated through-holes alongside them to give
you the choice of either plug and play or soldering directly to the board. The general hardware pinout v1.0 is
broken out on the edge of the board. Your mileage may vary depending on the processor board that you are using.
Qwiic and I C
There are two locations on the board for your favorite Qwiic-enabled device. IN addition to the Qwiic conenctors,
we also have pins that are broken out on the should you need to use jumeper wires or solder wire direction to both
boards. There are mounting holes for each standard 1.0"x1.0" Qwiic-enabled device.
Reset and Boot Buttons
The reset button will reset the processor. The boot button will put the processor into a special boot mode.
Depending on the processor board, this boot pin may not be connected.
2
