34
MAXITROL GV60 CONTROL SYSTEM
HOW TO TURN YOUR FIREPLACE OFF
(including pilot)
Familiarize yourself with each of these methods before operating your fireplace.
Handset and Wall Switch:
Press and hold the OFF button for a second (either on the handset or the wall
switch).
If the flames are on, they go down and you hear the valve motor wind down. You hear a clunk and a beep
indicating that the valve has received the signal from the remote control.
How to Ensure Your Fireplace Cannot Be Turned ON Inadvertently
You can use the following method to ensure that your fireplace will not turn on when you don’t want it on.
First, ensure your fireplace is turned off—including the pilot—and cold BEFORE going ahead
.
Close the shut-off valve on the gas supply line to the appliance.
Remove all batteries from the receiver as well as the battery from the handset.
Automatic Shut-Off
(in certain conditions)
Your fireplace’s remote control is equipped with an automatic shut-off mechanism which is activated in
certain conditions. See page 13 in the
Remote Control Operation
section for a description of this feature.
NOTE: Before using the remote control system for the first time,
the receiver and the handset are syn-
chronized at the factory. See the section
Remote Control Initial Set-up
on page 39 of this manual if the
receiver and handset lose synchronization.
IMPORTANT:
BEFORE YOU BEGIN, please note that on this system, the settings of time, temperature
and automatic ON/OFF
can only be programmed when the function display is flashing
. Be patient
when programming as it can take a few seconds to set.
Wall Switch
( optional)
Programmable Thermostatic
Remote Control