TECHNICAL SUPPORT - tel. +48 71 31 59 068
NOTES
1.
Do not replace any components in the detector, except the batteries.
If you notice any malfunction, please contact your distributor. Do not
repair the device on your own.
2.
Do not install the detector in the locations where the humidity or
dustiness are high. Make sure the vents in the cover are not blocked
with dust, oils and other substances.
3.
The device should be installed in rooms which have been finished off
and painted.
4.
Run a test on the device once per month.
5.
If the device emits sounds every 30-40 seconds, this means partly.
6.
Any damage caused by leaking water is excluded from the warranty.
INSTALLATION
SD\1B sensor is intended for use in the rooms where the potential fire
risk is the highest. When installing the sensor make sure it will be heard
from other rooms in the building as well. The optimal location is the
ceiling of the room.
1.
Separate the mounting base from the body of the device by turning
it anti-clockwise.
2.
Insert a 6LR61 9V battery into the device.
3.
Test the device by pressing the button on the cover until a sound
from the speaker can be heard. The sound from the speaker indicates
that the device is working properly.
4.
Mark 2 spots for mounting bolts on the ceiling, using the 2 holes in
the mounting base. Then, drill 2 holes of the proper diameter in the
ceiling and insert the mounting bolts (included). Mount the base on
the ceiling using the screws. Attach the body of the device to the
base using 2 hooks in the perimeter of the base, matching the two
oblong holes, located in the body. When the elements are fitted turn
the body to the right.
