Power Switch
Low Speed
Medium Speed
Light Switch
High Speed
Range Hood Operations & Wiring Diagram
Turn On:
• Press the speed control (Low Speed, Medium Speed, High Speed) switch to select the desired level of power.
Once button is pressed, the previous speed mode will cancel.
• Press the Light Switch to power on the lights.
CAUTION: DO NOT touch the lights until switched OFF and cooled.
Turn Off:
• Press the Power Switch to turn off the power.
• Press the Light Switch to power off the lights
SV300 Series Standard Class (3 Speed Mechanical Control)
NOTE:
Wiring Diagrams shown above with GU10 light configuration. A transformer is required for MR16 Lights.
SV400 Series Standard Class Wiring Diagram -Push button
Page 15
9. Have a third person raise up and hold the island range hood in position, connect power plug to the 12” hanging
electrical cord, and connect the duct work to the range hood.
10. Mount the hood to the lower support frame using four “D” bolts and four “E” nuts: Securely fasten two “E”
nuts to two “D” bolts by reaching up from the underside of the hood. Repeat this step to secure the other side
using two “E” nuts to two “D” bolts.
11. After all four “D” bolts and four “E” nuts securely fastened, connect the lower end of the duct tube to the hood
and slide the lower chimney cover down carefully so that it sits on top of the hood.
12. Install grease cup and aluminum filters then check the operation of the range hood.
Island Hood Installation Overview
Installation: Island Hoods-2
