5
Cleaning the hot tub -
After the water has been used in a hot tub so it should be emptied out. The hot tub
is then rinsed out with clean fresh water. If the water has been in it for a long time, it should also be scrubbed
with soap. If you have a stove from SpaDealers so it should always be emptied of water.
Heating device -
Always read the separate instructions supplied with the heating device, for example,
wood stove or gas heater. Be sure to follow them and take also into account the possible risk of freezing.
Function of Stove
The stove has a water flow control, is fully automatic and easy to use. Before the pump there is a filter which
ensures that debris is not sucked in and it’s important that it’s kept clean. The most common problem that
can occur is when dirty water is used and the filter gets clogged. This causes the water flow to diminish. The
stove then switches off. No temperature is shown in the display and no spark. The problem is solved by
cleaning the filter.
USE THE RIGHT LOW PRESSURE CONTROLLER
The types of gas cylinders and connection methods of low pressure regulators (30mbar, 2kg / h) can vary. It is
important that the correct low pressure regulator is used. Here are examples of the right type and also
incorrect types.
NEVER USE an adjustable controller.
Examples of correct gas reducers and incorrect ones
Note that the amount of gas that the stove needs to give full effect is 1.6 kg / h. With a flow of 1 kg / h, the
effect is 60% less. So the most optimal is 2 kg / h.
BEFORE STARTING
Check that the gas type corresponds to that stated on the rating plate, see page 2 in the stove's operating
instructions. CHECK THAT THERE ARE NO GAS LEAKS! Open the gas valve and see instructions on page 7 in the
stove's operating instructions.
START UP>
Start the pump, the ignition switch (
11
) is activated via
ON / OFF
, the ignition switches on and
"on" sound occurs during the ignition procedure, the sound stops after the gas burner has started; hot water
comes out.
NOTE
: When using the stove for the first time, or after a long period of inactivity, repeated ignition
attempts are needed to remove any air in the gas line.
