Spacelabs qube 91390, Service Manual

Page: 83 / 160

www.spacelabshealthcare.com 4 - 2 9
9 1 3 9 0
Q U B E
M
A I N T E N A N C E
Figure 4-25 Recorder Assembly and CPU PCBA
To replace the recorder
1 If the recorder assembly is installed, open the printer door.
Loosen the two captive screws. Pull out the assembly at the
top. Refer to
Figure 4-25 .
2 To reinstall, use the instructions in Step 3 on page 4-28.
Insert Recorder Paper
Two rolls of thermal recorder paper are included with the optional
recorder assembly.
To insert a roll of paper
1 Press the release bar at the right of the recorder assembly.
The front of the recorder assembly is hinged at the bottom.
Two spoon-shaped arms that hold the paper roll spindle
between them drop down.
2 Unroll a short length of paper from the roll. Orient the roll so
that the paper feeds from the bottom.
3 Slip the paper roll spindle between the plastic arms. Close the
front of the assembly so that the end of the paper roll sticks out
of the recorder assembly.
Dock Connector Covers for Option A
The covers are snap-on and snap-off, and can be removed by hand.