Spacelabs qube 91390, Service Manual

Page: 64 / 160

www.spacelabshealthcare.com 4 - 1 0
9 1 3 9 0
Q U B E
M
A I N T E N A N C E
Figure 4-4 Bezel Assembly and Rear Enclosure
5 Start from the bottom and disconnect the three black wire
bundles from the monitor side. Refer to
Figure 4-4 .
6 Remove the video cable P/N 175-1856-00 from the monitor.
7 Disconnect the remaining black ribbon cable from the monitor
side. Refer to
Figure 4-4 .
8 Remove bezel assembly.
Reassembly
1 Position the new bezel assembly as shown in Figure 4-4 .
2 Connect cable 175-1855-xx Com4 to J941 (CPU).
3 Connect cable Center Video Port 175-1858-xx to J40 (CPU).
4 Connect cable 175-1856-xx to J261 (CPU).
5 Connect cable 175-1857-xx Com1 to J50 (CPU).
175-1855-xx Com4 to J941 (CPU)
Touch Screen
Flat Ribbon Cable - P341 (CPU)
Center Video Port
175-1858-xx - J40 (CPU)
Center Video
Port - J40
(CPU)
175-1857-xx Com1 to J50 (CPU)
175-1857-xx Com1 to
J50 (CPU)
175-1856-xx to J261 (CPU)
Caution:
Use caution when handling the cables. The cables are fragile and can
easily be damaged.