PART
QTY
1.
Base . . . . . . . . . . . . . . . . . . . . 1
2.
Casters . . . . . . . . . . . . . . . . . . 5
3.
Pneumatic Cylinder . . . . . . . . . 1
4.
Seat Plate . . . . . . . . . . . . . . . . 1
5.
Seat Cushion . . . . . . . . . . . . . . 1
6.
Back Assembly . . . . . . . . . . . . 1
7.
Arms (7L & 7R) . . . . . . . . . . . . 2
8.
Flat Washers . . . . . . . . . . . . . . 6
9.
Phillips Screws . . . . . . . . . . . . 6
10.
Small Phillips Screws. . . . . . . 4
11.
Allen Screws . . . . . . . . . . . . . 3
12.
Back Support (pre-installed) . 1
13.
Allen Wrench . . . . . . . . . . . . . 1
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1
Insert five Casters (2) into Base (1), push hard until you feel or hear the Caster (2) snap into place.
STEP 2
Align holes of Arms (7L & 7R) with holes of Seat Cushion (5), secure Arms (7L & 7R) using three Phillips Screws (9) and three Flat
Washers (8) for each Arm (7).
FULLY TIGHTEN ALL SCREWS.
STEP 3
Attach Seat Plate (4) to Seat Cushion (5) with the arrow towards the front of the chair, using four Small Phillip Screws (10),
TIGHTEN ALL FOUR SCREWS COMPLETELY.
STEP 4
Attach Back Support (12) to rear end of Seat Plate (4) using three Allen Screws (11),
FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (13).
STEP 5
Insert Pneumatic Cylinder (3) into Base (1), Place the assembled seat on top of Pneumatic Cylinder (3) and
apply downward pressure.
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.
© Office Star Products February 2008
Phillips Screwdriver also needed for
assembly (not provided)
7L
5
1
3
4
12
8
2
x3
x4
13
x5
x3
x3
x3
x3
1
4
11
8
9
9
7R
10
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
6
2387C PROFESSIONAL AIR GRID BACK
AND FABRIC SEAT MANAGERS CHAIR
ASSEMBLY INSTRUCTIONS
