PART
QTY
1.
Base . . . . . . . . . . . . . . . . . . . . 1
2.
Casters . . . . . . . . . . . . . . . . . . 5
3.
Pneumatic Cylinder . . . . . . . . . 1
4.
Seat Plate . . . . . . . . . . . . . . . . 1
5.
Seat Cushion . . . . . . . . . . . . . . 1
6.
Back Assembly . . . . . . . . . . . . 1
7.
Arms (7L & 7R) . . . . . . . . . . . . 2
8.
Arm Screws . . . . . . . . . . . . . . . 8
9.
Seat Plate Screws . . . . . . . . . . 4
10.
Allen Screws . . . . . . . . . . . . . 3
11.
Back Support (pre-installed) . 1
12.
Allen Wrench . . . . . . . . . . . . . 1
13-V22N1WA, 13-V44N1WA, 13-V66N1WA,
13-V77N1WA & 13-V88N1WA
DELUXE CHAIR w/ VeraFlex™ BACK
ASSEMBLY INSTRUCTIoNS
© Office Star Products February 2008
Phillips Screwdriver also needed for
assembly (not provided)
12
10
5
1
3
6
8
8
7L
7R
9
X4
X4
X5
X3
4
4
11
x4
2
STEP 1
STEP 2
STEP 3
STEP 4
STEP 5
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1
Insert five Casters (2) into Base (1), push hard until you feel or hear the Caster (2) snap into place.
STEP 2
Align holes of Arms (7L & 7R) with holes of Seat Cushion (5), secure Arms (7L & 7R) using three Arms Screws (8) for each Arm,
FULLY TIGHTEN ALL SCREWS USING PHILLIPS SCREWDRIVER (not provided).
STEP 3
Attach Seat Plate (4) to Seat Cushion (5) with the arrow towards the front of the chair, using four Seat Plate Screws (9),
FULLY TIGHTEN ALL SCREWS USING PHILLIPS SCREWDRIVER (not provided).
STEP 4
Attach Back Support (11) to rear end of Seat Plate (4) using three Allen Screws (10),
FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (12).
STEP 5
Insert Pneumatic Cylinder (3) into Base (1), place the assembled seat on top of Pneumatic Cylinder (3) and apply downward pressure.
ATTENTIoN: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFoRE USING CHAIR.
5
