PART
QTY
1.
Base . . . . . . . . . . . . . . . . . . . . 1
2.
Casters . . . . . . . . . . . . . . . . . . 5
3.
Pneumatic Cylinder . . . . . . . . . 1
4.
Footring . . . . . . . . . . . . . . . . . . 1
5.
Seat Cushion . . . . . . . . . . . . . . 1
6.
Back Assembly . . . . . . . . . . . . 1
7.
Allen Screws . . . . . . . . . . . . . . 4
8.
Back Support (Pre-Installed) . . 1
9.
Allen Wrench . . . . . . . . . . . . . . 1
1
Remove all parts from carton, separate by part numbers indicated on parts list, and verify part quantities.
STEP 1
Insert five Casters (2) into Base (1), push hard until you feel or hear the Caster (2) snap into place.
STEP 2
Slide Pneumatic Cylinder (3) through Footring (5) and into Base (1).
STEP 3
Attach Back Support (10) to rear of Seat Cushion (6) using four Allen Screws (9),
FULLY TIGHTEN ALL SCREWS USING ALLEN WRENCH (11).
STEP 4
Place the assembled seat on top of Pneumatic Cylinder (3) and apply downward pressure.
ATTENTION: MAKE SURE ALL SCREWS ARE FULLY TIGHTENED BEFORE USING CHAIR.
13-37N20D DRAFTING CHAIR
ASSEMBLY INSTRUCTIONS
© Office Star Products June 2007
STEP 1
STEP 2
STEP 4
2
3
4
X5
3
1
STEP 3
9
7
8
X4
5
6
7
