Form 44201360
40
Oct 2019
REPLACING PARTS
21.0)
REMOVAL OF GLASS PANEL
21.1)
1.
Remove the glass retainer 1.
2.
Carefully slide the glass panel 2 from the retainer rails and away from heater. Access to the gas
control valve and ignition module can now be made by loosening the screws from the access panel
assembly.
3.
Clean the glass with a glass cleaning solvent. Inspect for any cracks.
4.
Inserting the glass:
4.1.
The side of the glass where the logo emblem is attached must be slid in first for the logo emblem’s
final position to be at the control side of the heater.
4.2.
Slide the glass into the “Glass Retainer Rails”. The glass must be held parallel to the Glass
Retainer Rails during assembly. The glass will slide in easy with ample clearance. Slide the glass
until it is positioned under the Glass Retainer at the heaters control enclosure side. At this point
the glass will be flush with the heater at the insertion point.
Note: If the ceramic glass does not slide in easily review position of ceramic glass to glass retainers and
adjust if needed. Do not force the ceramic glass into the glass retainers!
5.
Reinstall the Glass Access Retainer 1 removed in 1 with the two (2) sheet metal screws.
