G. Program PixiePlus: Place the wand so that it is lined
up against the top of the PixiePlus bezel as shown. Be
sure the plastic window of the Wand which faces toward
the PixiePlus is lined up with the two small circular
openings on either side of the bezel, the one labeled
“aim remote to be learned here” on the right and the
matching opening on the left side.
Press and hold the
Write/on
button until the
Programming Wand illuminates. Then press the
Write/on
button again to set it to programming mode.
The wand will begin beeping about once a second.
It will begin chirping quickly, indicating that it is
communicating with the PixiePlus. If it beeps slowly but
does not communicate with the PixiePlus, try adjusting
the angle of the wand slightly.
Programming the PixiePlus with a new configuration
usually takes 15-30 seconds. When the programming
session is complete, you will hear confirmation: either
"da - da -^daaa" (three tones with the last one ascending) indicating success, or "^Da
-da" (two tones with the second one descending) indicating failure. If the session fails or
times out, try programming the PixiePlus again by repeating step 7.
TIP
: If the Wand does not begin rapidly chirping when you hold it against the PixiePlus,
it is probably not establishing contact with the PixiePlus. In that case it will beep slowly
for five to ten seconds until it times out. If this occurs, try adjusting the angle of the
Wand. Keep the plastic window lined up with the top of the bezel as described above, but
bring the bottom of the wand up an inch or two and move it around slightly until you find
the “sweet spot.”
3.
Using the Programming Wand to Set Schedule Events
The Programming Wand is used to set time on the PixiePlus Real Time Clock Module
(PXE-DCM-RTC, included) and to schedule behaviors such as sending
Power Off
commands or locking the interface at specified times. Events may be scheduled for
certain days of the week, date ranges, or for any combination of the two.
Important
: If you wish to wish to configure PixiePlus schedule events
without erasing
the preconfigured Epson codes
, you must use the
Set Mode
feature to deactivate the
Programming Wand's
Code
programming functions. See step E below for more
information.
If desired codes are accidentally changed or deleted, they may be restored to the default
preconfiguration by following the procedure described in s
ection
above.
4
