SY-P4RS350 / P4RC350 Quick Start Guide
Hard disk/FDD/ CD-ROM issues
My Western digital HDD is not detected during boot-up
Change the jumper settings to cable select or single.
Sometimes the system finds my CD-ROM, sometimes not
1. Check CD-ROM if it is working properly.
2. The power supply might not have enough wattage to support all the
peripherals. If your system has other peripherals connected, like CD-RW,
extra HDD, etc. disconnect them.
When I boot up my new computer I get "floppy boot failure" and the LED
on the floppy stays on
1. Make sure the red wire of floppy ribbon cable goes to Pin1 on the floppy drive
side (don't trust the "key lock" or "notch") and use the end-connector of the
cable (don't use middle one).
2. Some floppy drivers have their own jumper to make the same twist as the
twist on the cable. Make sure this jumper is set not to “twist” the cable while
the floppy drive is connected to the twisted end of the cable.
LAN Issues
During LAN driver installation, the system hangs on 75%, why?
Enable the onboard LAN in the BIOS setup.
I have problems installing Novell NetWare v.50
Disable the APIC option in the BIOS.
For more FAQ update please check
http://www.soyousa.com/support/
28
