SY-D6IBA2
Quick Start Guide
11
Quick BIOS
Setup
3
3
Quick BIOS Setup
This Motherboard does not use any hardware jumpers to set the CPU frequency. Instead,
CPU settings are software configurable with the BIOS
[SOYO COMBO SETUP].
The
[SOYO COMBO SETUP] menu combines the main CPU parameters that you need to
configure, all in one menu, for a quick setup in BIOS.
After the hardware installation is complete, turn the power switch on, then press the
<DEL>
key
during the system diagnostic checks to enter the Award BIOS Setup program. The CMOS
SETUP UTILITY will display on screen. Then, follow these steps to configure the CPU settings.
Step 1.
Select [LOAD SETUP DEFAULT]
Select the “LOAD SETUP DEFAULT” menu and type “Y” at the prompt to load the BIOS
optimal setup.
Step 2.
Select [STANDARD CMOS SETUP]
Set [Date/Time] and [Floppy drive type], and then set [Hard Disk Type] to “Auto”.
Step 3.
Select [SOYO COMBO SETUP]
Move the cursor to the
[CPU Speed]
field to set the CPU working frequency.
Available [CPU Speed] settings on your SY-D6IBA2 Motherboard are detailed in the
following table. If you set this field to [Manual], you are then required to fill in the next two
consecutive fields: (1) the CPU Host Clock, and (2) the CPU Ratio.
CPU Frequency
233MHz (66 x 3.5)
350MHz (100 x 3.5)
266MHz (66 x 4.0)
400MHz (100 x 4.0)
300MHz (66 x 4.5)
450MHz (100 x 4.5)
333MHz (66 x 5.0)
500MHz (100 x 5.0)
366MHz (66 x 5.5)
550MHz (100 x 5.5)
400MHz (66 x 6.0)
600MHz (100 x 6.0)
433MHz (66 x 6.5)
Select the working frequency of
your Pentium
®
III,
Pentium
®
II
processor among these preset
values.
Note:
Mark the checkbox that
corresponds to the working
frequency of your Pentium
®
III,
Pentium
®
II
processor in case the
CMOS configuration should be lost.
Step 4.
Select [SAVE & EXIT SETUP]
Press
<Enter>
to save the new configuration to the CMOS memory, and continue the boot
sequence.