AR-837-E / EF
V200929
ACCESS & INDUSTRIAL CONTROL
RESET
Restoring Factory Settings
Firmware Upgrade
Reset all device parameters and user card data
Reset IP Setting:
When the device's power is on, press the
【
RESET
】
button on the main board untill the ERR (Red)
LED of screen lights up. (Refere to the picture beside)
※
After operation as above, you will hear a long reminder sound,and wait until the sound disappears,
and then reset the power of the controller. The device will be restored to factory settings.
Reset all device parameters and user card data:
Access programming mode
→
Parameters2
→
Factory Reset
→
0 : System Param
;
1 : User Setting ; 2 : System & User
9
4
5
Get the upgrade software from SOYAL or our distributor and run “UdpUpdater” software
Update the firmware
[Please login the SOYAL website to download the new ISP Firmware.]
1. Input the Target Address and Port
2. [Load F/W] open the documents that have the new ISP Firmware
3. Click the new ISP Firmware and [Open] it
4. Click [Update F/W] to start the firmware update
5. Till the screen shown [Firmware Update is Complete]
Execute the software
The software is within SOYAL CD or please login the SOYAL website to download
1
2
5
4
3
※
After having done the "Factory Reset," the External Communication Port must be reset. Or
the biometric sensor won't be functional.
Tools → Ext. Comm Port (0:FP-200
; 1:Lift ; 2:Vein2000 ; 3:FP-9000 ; 4:Reserved )
5
P. OpenZone
Q. Open TimeZone
Access programming mode
→
Parameters[1]
→
OnOff OpenZone
→
Main Controller Auto Open Zone
(0:disable, 1:enable)
→
Open Door Imm. During Open Zone
(0:No, 1:Yes)
→
WG1 Port Auto Open Zone (0:disable, 1:enable)
→
Open Door Imm. During
Open Zone
(0:No, 1:Yes)
→
Succeeded
3
2
Access programming mode
→
Tools
→
Open TimeZone
→
Set (00~15)
→
Time
(24
Hours)
;
Main Port (0:disable, 1: enable) ;
WG Port (0:disable, 1: enable)
→
Weekday
(0:disable, 1: enable)
→
succeeded
5
6
