b.701Server software
(1)Tick Node ID
(2)Tick IP and key-in the new IP address you had changed by
Net 727 Software.
c. Click “Hyper-Terminal”. Shown as follows:
d. Key-in any temporary name. It is not important
matter.
e. Choose which COM port that Converter
connect and click “ OK ” to exit.
f. Set Port Settings to 9600, 8, None, 1, None
and click “OK” to save.
g. TCP/IP module already gets IP address now
shown as follows:
h. Please refer above item and enter
item on the so that set all parameters.
i. Note that enter item 6 on the to save
parameter after finished setting up
parameter.
j. Then switch DIP SW-1 and SW-2
to “OFF” position.
1
2
3
C.Software Operation
1.Set up communication port at 701Server software. 2.Node ID setting
a.Hardware
Power Off → Take off the battery
connector from BAT+ socket →
Set up node number by
8 dip-switch → Plug in battery →
Re-apply the power
3.Get IP address by COM Port
At first, PCB diagram as follows and Connect a Converter (RS485 to RS232) to the HOST of the PCB:
1
2
3
4
Switch DIP SW-1 to “OFF” position.
Switch DIP SW-2 to “ON” position.
(Serial Setup Mode)
Switch Jumper J3, J4 and J5 to
RS-485 position.
Switch Jumper J2 to RS-485
position.
a. Power on.
b.To modify parameter on the TCP/IP module through the
Hyper-Terminal function of the Window.
(Start → Programs → Accessories →
Communication → Hyper Terminal)
1
3
4
2
v070604
4
TCP/IP module Ver: 2.07
AR-716E
SOYAL
