8
Customer Helpline
01904 727503
www.gardenservicecentre.co.uk
Assembly
Step 3 - Connection to the power supply
WARNING!
Read all of the instructions of this manual before attempting to connection the
power supply for your tool. Switch on the chainsaw only when chain bar, saw chain and
sprocket chain wheel covering are correctly assembled.
WARNING! If the insulation on a power cable or extension lead is found to be cut or
damaged, do not touch it! Disconnect the power supply immediately and have the
damaged cable replaced by authorized service agent.
WARNING! If operating the appliance in a damp location is unavoidable, use a residual
current device(RCD) protected supply.
Use of an RCD reduces the risk of electric shock.
WARNING!
Use only extension cords suitable for outdoor use, preferably with a high visibility
cable colour. Always unwind all extension cables fully, coiled cables can overheat and reduce the
efficiency of your product.
NOTE!
For extension cables up to 15metres, use a wire cross section of 2.5 mm
2
.
WARNING!
This product is designed to operate on 230-240 VAC 50Hz. The voltage and current
must comply with the information on the ratings label!
NOTE!
This electric chainsaw is fitted with a non-rewireable plug. If it is necessary to change
the fuse in the plug, the fuse cover becomes lost or damaged; the plug must not be used until a
suitable replacement is obtained.
WARNING! A 13amp fuse must be fitted.
1). Make sure the on/off switch (3) and safety chain brake trigger (10) is in its off position.
2). Double the extension cord about a foot from the end. Lead the loop through the hole on the
rear handle and hook the loop over the cord restrainer. Gently pull on the cord to ensure that it is
firmly attached at the handle.
3). Connect the cord to a suitable socket.