14
Operation
Start up
ON/OFF operation
Overload protection
Restart prevention
Check that the mains voltage matches the rating on the
name plate.
Hook the collection bag
4
into the bag mounts
3
.
Avoid filling the collection bag too much. The bag will fill
unevenly under the discharge duct!
• Turn off the unit.
• Remove and empty the collection bag
4
.
If your shredder is fitted with a long mains cable, plug it directly
into the mains supply, using an RCD device if necessary.
Make sure that the funnel feeder is empty.
• Set the On/Off switch
10
to ‘ON’ to turn on the unit.
To begin shredding, feed the material into the opening of
the hopper.
• Set the On/Off switch
10
back to ‘OFF’ to turn off the unit.
The shredder will continue to run for a few seconds after
switching off.
In the event of overload, e.g. due to branches that are too
thick, the equipment automatically switches off.
To restart the unit, wait a few minutes for the motor to cool
down, press the Reset button
8
, then turn on the unit.
The unit will not automatically restart when the power returns
after a power cut. To restart the unit, turn the ON/OFF switch
to ‘OFF’ then back to ‘ON’.
