WARNING
:
Tool Use Hazards
• The normal use of this product is to heat PVC and other roun
d
thermosetting plastics only.
• The use of this product for purposes other than heating PVC pipe
or working with thermosetting plastic is considered a violation
of the warranty.
• Place your PVC Bender unit on a secure, dry surface, in a we
ll
ventilated area.
• Disconnect and turn off the unit during work delays.
• Keep flammable and combustible materials away from the unit
and around the work area when unit is in operation.
• Connect each unit to the proper amperage capacity circuitry and
grounded power source. Be careful not to overheat or overlo
ad
your power source.
• We strongly recommend the use of a Ground Fault Circuit
Interrupter (GFCI) protection when using this unit on any job site.
• We strongly recommend using an extension cord that is 10 AWG
or 12 AWG to prevent the cord from overheating, causing current
loss. Current loss occurs with the natural resistance of electricity
flowing through copper wire acting like friction, reducing the
available voltage. Using long (ex. 25 foot or longer) and /
or
undersized (ex. 16 AWG or 18 AWG) extension cords can reduc
e
the heat output of the heating element because of the resistance
that occurs resulting in slower bending times.
• Keep all decals clean and legible, and replace when necessary.
• Think Safety First!
CAUTION
:
Make su
r
e bystanders a
r
e clear of the work a
rea
when utilizing this bende
r
. Nearby personnel can be inju
r
ed if the
re
is a malfunction.
• If tool is in disrepair, DO NOT USE. Have tool serviced at an
Authorized Southwire Repair Center.
FAILURE TO OBSERVE THESE CAUTIONS CAN RESULT IN
INJURY OR PROPERTY DAMAGE
4
IMPORTANT SAFETY INFORMATON
