Page 6 of 9
Copyright 2010 Southwestern Microsystems Inc. All rights reserved.
Inserting/Removing the SD cards:
o
The Music-In-A-
Flash player utilizes a SD socket which is a “push-push” design
similar to many cameras.
Verify the power switch is off.
To insert SD card, contacts must be facing down along front edge of
card (SD card label should be visible).
Push card into slot with a
finger until a “CLICK” is heard.
Gently release pressure on SD card and card should stay in player.
If properly seated, SD card should barely stick out of front panel.
To remove, push on card with a finger
until the “CLICK” is heard and
slowly move finger away. Card will stick out of front panel approximately
¼
” when released. Pull card out of slot as it is free.
The SD cards are loaded with many songs of easy listening classical
music.
o
Depending on your music choices, some music may be much louder than
others. Try to balance all channels to about the same output level.
The Music-In-A-Flash
™ player must be operational to set audio levels.
See picture on page 3 for audio output volume adjustment
potentiometers (pots) locations at back of player.
Rotating white pots, with small screwdriver, counter clockwise - reduces
the audio output volume.
Audio output volume level is set at mid-level by manufacturer.
Each channel
’s audio output level on Music-In-A-Flash™ player is
independently controllable.
This concludes Section 1 - Installation. Please refer to Section 2 for system operation.
