Page 3 of 9
Copyright 2011 Southwestern Microsystems Inc. All rights reserved.
Section 1A - Installation of Elegant Music System with a
single speaker
(Model #: MD-EMS1)
The Elegant Music System player must be installed indoors. If outdoor music is desired,
then outdoor rated remote speakers will need to be installed to provide the music.
Choosing a location
:
o
The Elegant Music System can be simply removed from the box and set in
the corner of your office or home OR
o
Position the player under a counter or in a less conspicuous space and
remotely mount the speaker on a wall using a wall hook and the spring
loaded loop on the back side towards the top of the speaker.
18 Gage speaker wire is a good choice for connecting the Elegant
Music System to any remotely mounted speakers
Choose a location so that the front of the player can be easily
accessed should you wish to change the SD card in the future.
o
Elegant Music System player should be located within 5 feet to a 110 volt
standard wall outlet for the power adapter.
Connecting to Power Source:
o
Verify switch on front panel is in the “off” position (fully extended position).
o
Plug wall transformer into standard 110 volt AC wall outlet.
o
Plug round barrel power connector on supplied transformer assembly into
hole, push until it stops, on back of player labeled 12VDC - see picture on
next page for details.
Connecting the Remote Speaker
– if speaker is not sitting atop EMS case:
o
We recommend using 18 gage clear jacket speaker wire. This wire has a
very specific look and has a less likely chance of being mistaken for a
power cord.
o
Measure & cut the wire to the desired length.
o
Separate the 2 conductors by cutting down the middle and pulling apart
approximately 1
½” in length. Strip ¼” of the insulation off both conductors
at both ends and give the wire strands a twist using your fingers. Easier to
install in Elegant Music System and Speaker wire connectors.
o
We recommend always using the copper colored wire or copper colored
wire
without white stripe
on insulation jacket as the positive (+)
conductor.