Questions? Call Toll Free at 1-800-737-2112
Copyright © 2012 MAT Engine Technologies, LLC
Read and follow the assembly instructions. Do not discard
any parts or materials until the unit is assembled.
References to the right or left side of the trimmer are from
the viewpoint of the operator’s position behind the trimmer.
WARNING
Do not operate trimmer if it is damaged or not completely
and correctly assembled.
WARNING
Before doing any assembly or maintenance to the unit,
remove the wire from the spark plug. The following compo-
nents will be found in the carton. Quantities shown in ( ).
(1) Trimmer
(1) Trimmer Operator’s Manual
(1) Container of Engine Oil
(4) 0.155 in. [4 mm] Trimmer Lines (2 sets)
Assembly
• Save all instructions
If you need assistance or find any parts missing, CALL
TOLL FREE: 1-800-737-2112.
How to Assemble the Handle
NOTE: Refer to Figure 2 when following the steps below
1. Attach upper handle assembly to lower handle by aligning
bolt holes and inserting provided handle bolts through
each side and assembling plastic wing nut.
How to Assemble the Wheel
NOTE: Refer to Figure 2 when following the steps below
1. Place the unit on a level surface.
2. Install steel spacers onto axle.
3. Install wheels and secure with flange nuts.
4. Install hub cap by pressing firmly in the center until the cap
snaps into place.
Wing Nut
Rope Guide
Handle
Recoil Start
Handle
Figure 2
Figure 3
Wheel
Hub Cap
Flange
Nut
Handle
Bolt
Steel
Spacer
6
Z-hook
Control Lever
Clip retainer
Control cable
How to Assemble the Control Cable to the Control Lever
NOTE: Refer to Figure 3 when following the steps below
After the handle has been assembled, install the control
cable as follows:
1. Insert z-hook into hole in the control lever (insert from
inside to outside).
2. Clip retainer into hole in handle.
3. To attach the recoil starter handle to the rope guide,
engage control lever, pull rope, twist the rope through the
rope guide mounted on the right side of the handle.
