ELECTRICAL
120/208 Volts AC or
120/240 Volts AC
60 Hz
Single Phase
30 AMP wiring required
NOTE:
MAKE SURE THE SUPPLY
POWER CORRESPONDS WITH
VOLTAGE SPECIFIED ON THE
NAMEPLATE.
WARNING:
CHASSIS MUST BE GROUNDED TO PREVENT POSSIBLE SHOCK HAZARD.
WARRANTY IS VOID IF THE OVEN IS CONNECTED TO ANY VOLTAGE
OTHER THAN SPECIFIED ABOVE.
ELECTRICAL INSTRUCTIONS
11
1. This Appliance is not equipped with a power cord from the factory.
2.
Power supply connections should be made with flexible conduit. Use a No. 12 AWG wire
suitable for at least 90˚ C.
3. Adequate means must be provided to limit the movement of this Appliance without depending
on or transmitting stress to the flexible conduit. A tethering kit is provided with
this Appliance that meets these requirements. This kit also contains installation instructions.
4. Power must be OFF at the breaker during installation of the power connections.
5. Electrical service is provided to the oven at the main terminal block located behind the access
panel in the lower rear left corner of the oven.
6. Before connecting power verify the correct voltage.
7. Once correct voltage is verified, replace access panel.
8. Attach tether cable to the oven and the wall that the outlet is located on.
Summary of Contents for DH-65
Page 5: ...1 2 3 4 5 6 7 8 9 10 11 12 13 4...
Page 13: ...12 DH 65 WIRING DIAGRAM...
