Note: Drilled hole or plastic anchor not required when
mounting to stud, use screw only. We do not supply
hardware for mounting on concrete walls.
Figure 1
Find a desired location and mark 2
locations for screws on wall.
One screw (for each unit) must be attached
directly into a wall stud. Wall anchor is not
needed when mounting to wall stud.
Drill one of marked 3/16" hole (for each
unit), this hole will be for the Plastic Anchor
(A).
Insert Plastic Anchor (A) into hole on wall
(use a hammer to help).
Using Phillips screwdriver, insert Screws
(B) into Plastic Anchor (A) and the other
into the wall stud. Turn screws until there is
a gap of approximately 3mm between
head of screw and wall.
Hang the Chartres Wall Décor onto the
Screws (B) and verify the Chartres Wall
Décor is resting securely on the mounting
Screw (B).
Now your Chartres Wall Décor is ready to
use.
Chartres Wall Décor
Assembly Instructions
"The hole measurements on
the wall must match with the
hole measurements on back
of the unit"
Page 3
Figure 2
