H3-EM-62-100 Electronic Swinghandle
Operating Instructions
J-H3-EM-62-100-M
Page 1 of 4
Package Contents
H3-EM-62-100 Electronic Swinghandle
with RFID Reader (qty1)
EM-0-45827 M3x25 POZIDRIV
®
Mounting Screws (qty 4)
EM-0-47151 M3x14 POZIDRIV
®
Mounting Screw (qty 1)
H3-EM-0-61927 Rotation Limiter (qty 1)
E5-C-04 Pawl Screw (qty 1)
EM-0-45826 Top Mounting Bracket (qty 1)
EM-0-45822 Bottom Mounting Bracket (qty 1)
Operating Instructions (qty 1)
H3-EM-62-100 Electronic Swinghandle with RFID Reader
1.
Handle
2.
RFID Reader
3.
Tri-Color Status LED
4.
Lock Plug
Features
Installed 13.56MHz / 125kHz RFID reader module with Wiegand
data output
Compatible with 13.56MHz RFID cards with 4, 7, or 8byte
Unique Identifiers (UID) and 125kHz prox cards
Remote lock and unlock capability
Single or multi-point lock actuation
Momentary or continuous lock actuation
Tri-color LED (blue/magenta/red) to indicate lock and handle
status
Manual lock override
Accommodates both left and right doors
For indoor use only
Specifications
Actuator Module
Supply Voltage (V
SUPPLY
): 12VDC to 24VDC (
NOTE
: Status LED will blink
red if the supply voltage is out of range.)
Standby Current:
50mA maximum at 12VDC
Operating Current:
200mA maximum at 12VDC (with no external
mechanical load applied to handle
Stall Current:
1A maximum (at 12VDC, limited to 2 seconds)
Operating Transit Time: 1 second maximum (
NOTE
: Power must be
present during transit times. If power is
removed while the lock slide is in transit, it will
complete it’s cycle when power is
restored.)
Electronic Unlock Time: 3 seconds minimum
Open Collector Outputs: Rated for V
SUPPLY
, maximum load
RFID Reader Module
Supply Voltage (V
CC
): 12VDC to 24VDC
Operating Current:
125mA maximum (no external devices
attached)
Transmit Frequency:
13.56MHz / 125kHz
DATA Signal Voltage:
5VDC
DATA Pulse Interval Time: 40µs
DATA Signal Delay:
2ms
Output Format:
Reverse Byte Order (13.56MHz cards)
Most Significant Bit First (125kHz cards)
Upper and Lower Parity Bits Included
Mounting and Installation
Please refer to Southco trade drawing J-H3-EM-62-100 for mounting and
installation details.
NOTE:
Use a #1 POZIDRIV
®
driver when installing the mounting
screws. See Southco trade drawing J-H3-EM-62-100 for additional details.
Read range distance may vary depending on card type, mounting
conditions, or environmental conditions. In some cases, the card
may need to make contact with, or be moved across, the RFID reader.
Wiring Diagrams
The H3-EM-62-100 contains two separate functional modules: the actuator
module and RFID reader module. The actuator module controls and
monitors the locking function of the swinghandle. The RFID module reads
the contents of a compatible RFID card and converts it to Wiegand format.
These two modules operate independently of each other and require
connection to an access control unit (
not provided
), as illustrated below,
for the entire product to be fully functional.
