10
4. Measurement
It should be checked that the item to be measured is voltage free.
1. Before turning the equipment On, connect the test leads to the item to
be measured and to the front panel terminals.
The alligator clamps in the drawings are only for illustration.
2. Using the test current selector
, choose the range and the current
to be used.
3. Choose the power supply to use. If you are going to use the battery,
advance to the following point. If you are going to use the mains
supply, plug the power cord into the connector
.
4. Switch the equipment On using the On/Off
.
5. The PRESS START message will appear showing that measurement
can be started. Press the Start
key. Depending on the position of
the test current control
the LOW CURRENT message will turn
up.
Summary of Contents for MPK-2000e
Page 16: ...18 Notes...
