5
OPERATING INSTRUCTIONS
Mode Button
Power Button
•
Pressing the power button will turn ON or OFF the unit.
•
When the unit is in ON mode, the power icon indicator light will be shown green.
•
When the unit is in OFF mode, the power icon indicator light will be shown red. When power OFF, unit will be
stopped, if heater is working before power OFF the unit, fan will have 20 seconds delay to ensure heat will not
be trapped inside the unit.
Note:
When plug the unit each time, 5 seconds fan and heater will turn on for internal check program.
Note:
The unit has a memory function with last settings for heating level and flame brightness effect, unless the
main power to the unit has been interrupted.
Temperature Setting
•
The temperature mode controls the heater’s thermostat setting.
•
Press UP Arrow Button or Down Arrow Button to scroll through the pre-set temperature range fro
m 59°F (15°C)
to 86°
F (30
°
C), ON & OF (OFF).
•
Hold the mode button for 3s, this allows the temperature unit changing from °C to °F or °F to °C. The unit
default is °F.
Note:
This function is only available if using the control panel.
•
When the ambient temperature is higher than the set temperature, heater will turn off automatically.
•
Press the mode button to cycle through the different functions. Each time the mode button is pressed, the
mode will enter the next function - Temperature, Timer or Flame Brightness.
Timer Setting
•
The timer setting shoud be used to set the countdown for the unit’s main power.
•
Press
Up Arrow Button or Down Arrow Button to adjust the timer setting from 0 hour (OFF) to 9 hours with 0.5
hour interval.
Flame Brightness Setting
•
The flame brightness mode should be used to set the flame brightness.
•
Use Up arrow button or Down arrow button to scroll through the flame brightness settings:
F0 (Flame OFF, only lowest brightest on ember bed), F1, F2, F3, F4, F5 (brightest).
Note:
Heater must be properly installed before it is used.