Version 5.2
Sourcefire 3D System Installation Guide
214
Restoring a Sourcefire Appliance to Factory Defaults
Using the Interactive Menu to Restore an Appliance
Chapter 7
3.
Monitor the reboot and invoke the restore process again:
•
For a keyboard and monitor connection, a red LILO boot menu appears.
Quickly press one of the arrow keys to prevent the appliance from
booting the currently installed version of the system.
•
For a serial or SOL/LOM connection, when you see the BIOS boot
options, press Tab slowly and repeatedly until the LILO boot prompt
appears:
LILO 22.8 boot:
3D-5.2 System_Restore
4.
Indicate that you want to restore the system:
•
For a keyboard and monitor connection, use the arrow keys to select
System_Restore
and press Enter.
•
For a serial or SOL/LOM connection, type
System_Restore
at the
prompt and press Enter.
In either case, the
boot
prompt appears after the following choices:
0. Load with standard console
1. Load with serial console
5.
Select a display mode for the restore utility’s interactive menu:
•
For a keyboard and monitor connection, type
0
and press Enter.
•
For a serial or SOL/LOM connection, type
1
and press Enter.
If you do not select a display mode, the restore utility defaults to the standard
console after 10 seconds.
Unless this is the first time you have restored the appliance to this major
version, the utility automatically loads the last restore configuration you used.
To continue, confirm the settings in a series of pages.
The restore utility copyright notice appears.
6.
Press Enter to confirm the copyright notice, then begin the second pass of
Using the Interactive Menu to Restore an
Second or Only Pass
Use the following procedure to perform the second or only pass through the
restore process.
To perform the second or only pass through the restore process:
A
CCESS
:
Admin
1.
From the main menu, select
5 Run the Install
.
2.
Confirm that you want to restore the appliance and continue with the next
step.
