Controls: Equalizer
| 11
10 |
Controls: Knobs
CONTROLS: EQUALIZER
One of the key features of the MWB Pro is the 7-band graphic equalizer.
The Equalizer is post distortion. Each band can be adjusted up or down
in 1 dB steps from -12 dB to +12 dB and the setting is indicated by the dis-
play. The display shows 1 dB steps by lighting adjacent LEDs with varying
brightness. The equalizer section has three controls:
BAND SELECT LEFT and RIGHT
The two buttons on either side of the EQ knob select the frequency band
to edit.
EQ KNOB
The equalizer knob changes the value of the selected band up or down in
1 dB
steps.
You can quickly and easily zero the equalizer by pressing both left and
right band select buttons at the same time. The equalizer display will
reset to a default “flat” setting.
DRIVE
The DRIVE control adjusts the gain of the signal going into the distortion
section. The higher the DRIVE, the more distorted the signal.
CLEAN MIX
The CLEAN MIX knob controls the amount of dry, unaffected signal going
to the output. The clean signal used in this control does NOT have any EQ
applied. This control is especially useful for getting back some of the low
end frequencies that can be lost in the pure distorted signal.
DISTORTION MIX
This adjusts the overall level of the distorted signal. Along with the
CLEAN MIX
knob, it can be used to balance the levels of clean vs. distor-
tion. Also, the overall output level can be increased by turning up both
clean and distortion mix levels.
DRIVE
CLEAN MIX
0
DISTORTION MIX
0
62 125 250 500 1K 2K 4K
+12
-12
0
<
>
+12
-12
0
(NG) (HG) (HS) (HA) (HR)
EQ Knob
Band Select Right
Band Select Left