18 |
Effect Types
Extended Mode: Dual LEDs lit
01x. 6-pole low-pass filter
02x. 4-pole low-pass with offset peaks
03x. Peak > 4-pole low-pass filter
04x. 4-pole low-pass > peak filter
05x. Peak > notch > 2-pole low-pass
06x. Band-pass filter
07x. Peak > notch > peak filter
08x. Notch > peak > notch filter
09x. Triple peak filter C
10x. Triple peak filter D
11x. Single notch filter
12x. Dual notch > 2-pole low-pass
Normal Mode: Single LED lit
01. 2-pole low-pass filter
02. 4-pole low-pass filter
03. Two parallel low-pass filters
04. Three parallel low-pass filters
05. Notch > low-pass filters
06. Peak filter
07. Low-pass > two peak filters
08. Triple peak filter A
09. Triple peak filter B
10. High-pass filter
11. Phaser - Dual notch
12. Phaser - Triple notch
Controls: Knobs
| 11
• DRIVE (Green LED):
Adjusts the amount of drive and distortion applied to the
wet signal. As the knob is rotated from its minimum position (fully counter-
c
filter effects. When the knob is at its default (center) position, the tone of the
signal is not modified. As the knob is turned clockwise, the tone of the output
will become brighter, with higher frequencies being boosted. As the knob is
turned counter-clockwise, the tone will become warmer, with the higher
frequencies being cut. The dry signal is not affected by the TONE knob.
lockwise) to its maximum position (fully clockwise), the amount of distortion
applied ranges from no distortion at all, to maximum distortion. The distortion
circuit is a soft clipper with an even, smooth distortion characteristic and a warm
spectrum at lower DRIVE settings. At higher DRIVE settings, the clipping
becomes more aggressive with sharper edges and more harmonics.
Distortion is applied before the filter. The pre-distortion signal is used to
modulate the filter, which enables more expressive and dynamic control of
the filter sweep even when high levels of DRIVE are used.
• TONE (Red LED):
Adjusts the tone of the wet signal, after the distortion and
Factory Defaults:
Given the number of different functions available on the OPTION knob, it can be
useful
created default settings for each effect type, which provide a good starting
point for dialing in an effect. You can recall these factory default values at any
time by pressing and holding the OPTION SELECT button until its three LEDs
blink green twice.
to “zero out” all of the controls to a default value. Source Audio has
Stingray Manual - pages 18, 11
Summary of Contents for Soundblox 2 STINGRAY
Page 1: ...SA224 USER S GUIDE...
