INSTALLATION $ ACCESSORIES
Note:
Bracket
Bracket
1.Putthe 2 brackets to the left and right side of the headunit.
2.Use screws to fix the brackets to the unit.
4. Consult with your nearest dealer if installation requires the drilling of holes or
other modification of the vehicle.
5. Install the car receiver in the dashboard.
6. Connect the wire harness & antenna to the car receiver being carefully
not to pinch any wires or cables.
7. Install the plastic outer trim ring onto the car receiver.
8. Reconnect the battery and run through all of the options on this car receiver
to ensure that everything is working correctly.
9. Particulars will vary widely depending upon the kind of your car and the car
you intend to install it in. Please choose the correct installation method
according to the actual situation of your car. Always contact the car
dealer or manufacturer if you have any questions.
1. Make sure the ignition is
turned off, and disconnect the
cable from the vehicle battery’s
negative (-) terminal. You never
want electricity running white
you install this 2-DIN car receiver.
2. Before installation, discon-
nect the wire harness and the
antenna.
3. Attach the brackets on the
both sides of the car receiver
with screws as shown as the
figure. Please buy from your
dealer according to the drilling
of holes size.
Package contains the following accessories for installation and operation of the
unit.
Screws
User Manual
Trim Ring
Remote
Mounting
Brackets
ACCESSORIES
(2)
8
(1)
2
(3)
1
(4)
Power Cable
Warranty Card
(6)
1
(5)
1
(7)
1
1
12
ISO A
ISO B
EN
