Soundstream REF1600.2, Owner'S Manual

Page: 8 / 32

[ 8 ]
KEY TO CALLOUTS
GND - Main ground connection. Bolt to a clean chassis point in the vehicle.
+12V - Connected to a fuse or circuit breaker, then to the battery’s positive terminal.
REM - Remote Turn-ON is connected to Radio's power antenna lead or a switchable
+12V - FUSES- Satellite channels power supply fuses.
Warning: Replace only with the same value fuses
Speaker Connection Terminal - Connect Speakers here - ensure correct polarity.
Subsonic Filter - Frequency adjustment control for Subsonic Filter.
Selectable X-Over LP/HP/FULL
LP
- Frequency adjustment control for Low Pass Filter
HP - Frequency adjustment control for High Pass Filter
Full - Full Range Signal Output
Hawkins Bass-EQ Control Adjustment
Frequency adjustment control for Hawkins Bass Control filter.
Hawkins Bass-Boost Control Adjustment
Varies from 0 to + 18 dB of boost when the Hawkins Bass Control circuit is engaged.
Input Attention: ATT. Switch ‘ON’ for high voltage input (4V to 12V) capability. This
switch ‘ON’ must be used for speaker level input on common ground headunits
or high voltage line drivers.
Input Gain - Input gain control variable from 150mV to 4V or 4V to 12V
RCA Inputs - Connect the RCA cables from source unit, or line driver to these
RCA connectors.
RCA Line Outputs - Left and right RCA Line outputs provides Full Range Signal.
Status LED - Indicates amplifier power. (Power: Green / Protection : Red)