15
ENGLISH
wf-u24 User manual
C. 4x Screws to fasten the receiver to the two rack adapters
NOTE: The kit doesn’t include screws to fasten the whole block (receiver and
adapters) to the 19” rack chassis.
WF-RACK KIT1 assembling
1. Remove the two plastic parts on two sides of the receiver.
2. Place the A adapter so that the two lateral holes match those on the receiver side.
3. Fasten the adapter using two screws as shown in the following picture.
4. Repeat steps 1 to 3 of this section on the other side of the receiver.
5. This hole is normally used to attach the extension cables supplied with the kit in
order to place the antennas of the receiver outside the rack. In the specific case of
WF-U24, however, these extensions and this hole are not used because the rear
antennas are not removable.
1
210mm
3
5
2
4
ATTENTION: Note that the antennas should be kept in a horizontal or vertical
position but with an angle of about 45° to one another as much as possible.
The maximum distance from the bottom of the receiver to the top of the
antenna in vertical position is 210mm; the maximum horizontal distance is
maximum 300mm.